Software and Hardware

SOFTWARE AND HARDWARE needed for our projects:

Pinhole camera:

• A large piece of 5mm thick foam core board
• A 2cm x 2cm flat piece of metal from a tin can
• Three 35mm spools
• A ballpoint pen 
• Black acrylic paint
• A strong craft glue
• A sharp knife for cutting through the foam core board 
• A metric ruler
• A needle
• A fine-grit sandpaper
• A flashlight or electric torch
• A metal straight edge to aid cutting

LED Mood Lamp:

• Arduino UNO board (older boards should be compatible)
• USB A and USB B connector cable
• Arduino solder-less breadboard shield
• 3 resistors (330 ohm)
• Red LED
• Blue LED
• Green LED
• Breadboard connector wire
• White paper
• Scissors
• Tape